Equipment set TP 601 – Basic level: Basic training in electrohydraulics

Equipment set TP 601 – Basic level: Basic training in electrohydraulics

New edition of electrohydraulics!

TP 601 is a logical further development of electrohydraulics for training and further education. The equipment set contains only electro-hydraulic circuits and control systems.

The number and version of the components are specifically adapted to the projects in the workbook. This is a cost-effective way of teaching the important training objectives.

This equipment set provides students with knowledge about the basic physical principles of electrical engineering and electrohydraulics, as well as how electrohydraulic and control technology components function and are used.

 

Training content

Power packs and components:

  • Design, mode of operation and areas of application of 2/2, 3/2, 4/2 and 4/3-way solenoid valves, as well as 4/2-way double solenoid valves
  • Design and mode of operation of electrical pushbuttons, switches and limit switches
  • Design and mode of operation of a relay
  • Knowing and accounting for the contact load capacity of electrical signal transmitters
  • Selecting and using hydraulic and electrical components according to economic criteria
  • Design and mode of operation of a pressure switch
  • Knowing different ways of sensing a cylinder's end position and selecting the right one

Hydraulic circuits:

  • Commissioning hydraulic circuits safely
  • Explaining and designing direct and indirect actuation
  • Creating and using a sequence table
  • Explaining and designing signal storage in the hydraulic power section
  • Selecting solenoid valves according to the technical control requirements
  • Using and designing basic logic functions
  • Explaining and designing an electric latching circuit with a dominant switch-off signal
  • Designing and arranging pressure-dependent control systems
  • Knowing simple operating modes and accounting for them in the circuit
  • Electrically and mechanically locking of signals in a relay control system
  • Expanding existing control systems and adjusting the documentation accordingly Implementing sequence control with two cylinders
  • Getting to know and creating a procedure description as GRAFCET and as a function diagram
  • Analysing circuits and carrying out systematic fault finding and error elimination with restart

Measurements and calculations:

  • Measuring and calculating the flow in an electrohydraulic installation
  • Calculating electrical characteristic values

 

Also order:

Workbook

The basic electric circuits for hydraulic control technology are presented in 15 exercises. In order to carry out the exercises, students require the equipment set of TP 601 Electrohydraulics, Basic Level.

The workbook contains:

  • Sample solutions
  • Training notes
  • Multimedia USB-Stick with or download access to graphics, photos of industrial applications, animations and FluidSIM® circuit diagrams
  • Worksheets for students

Supplementary media

  • Designing and simulating with FluidSIM®
  • Measuring and controlling with FluidLab®
  • eLearning course: Electrohydraulics
  • Textbook Basic principles of Hydraulics and Electrohydraulics
  • Hydraulics poster set

 

Recommendations for accessories, media and extensions

 

The most important components at a glance

Type